TCI BTLT 2×21 T5 Electronic Ballast – 137998/221 – £16.52

This is the BTLT 2×21 T5 Electronic Ballast, suitable for running: 2 x 13w, 14w or 21w T5 fluorescent tubes.


TCI BTLT 2x21 T5 Electronic Ballast - 137998/221

Manufacturers Part No (where applicable) : 137998/221

This TCI product is available for just £16.52
at LampShopOnline Ltd


View Item

TCI BCC126 Matchbox Ballast – £10.79

TCI BCC126 is a non-dimmable ballast to run: 1 x 24w T5 Tube 1 x 24w PL-L Lamp 1 x 26w TC-D Lamp 1 x 26w TC-T Lamp Height: 18mm Length: 80mm


TCI BCC126 Matchbox Ballast

Manufacturers Part No (where applicable) : BCC122

This TCI product is available for just £10.79
at LampShopOnline Ltd


View Item

TCI BCC116SL Matchbox Ballast – £10.79

TCI BCC116SL is a non-dimmable ballast to run: 1 x 4w, 6w, 8w, 13w or 14w T5 Tube 1 x 10w TC-D Lamp 1 x 10w or 16w 2D Lamp 1 x 16w T8 Height: 18mm Length: 150mm


TCI BCC116SL Matchbox Ballast

Manufacturers Part No (where applicable) : BCC126SL

This TCI product is available for just £10.79
at LampShopOnline Ltd


View Item

TCI BCC124SL Matchbox Ballast – £10.79

TCI BCC124SL is a non-dimmable ballast to run: 1 x 24w T5 Tube 1 x 14w, 18w or 25w T8 Tube 1 x 24w TC-L/F Lamp 1 x 22w T5 Circular Lamp Height: 18mm Length: 150mm


TCI BCC124SL Matchbox Ballast

Manufacturers Part No (where applicable) : BCC124SL

This TCI product is available for just £10.79
at LampShopOnline Ltd


View Item

TCI 50w 350mA-1050mA Constant Current LED Driver – £3.56

You are viewing the TCI 50w 350mA-1050mA Constant Current LED Driver. This is a multi power driver supplied with a dip switch for the selection of different output currents, suitable for indoor use with an IP20 Rating. The switchable wattages are from 25w – 50w from a current of 350mA – 1050mA. See the Full Spec sheet HERE


TCI 50w 350mA-1050mA Constant Current LED Driver

Manufacturers Part No (where applicable) : 122204

This TCI product is available for just £3.56
at LampShopOnline Ltd


View Item

TCI 55w 1050ma MaxiJolly HC BI Dali Dimmable LED Driver (122417) – £5.99

This is a TCI 55w 1050mA MaxiJolly Dali dimmable constant current LED driver. The full features list is as follows: •Multipower driver supplied with dip-switch for the selection of the output current. •IP20 independent driver, for indoor use (DC MAXI JOLLY HC/2 DALI). •Class I protection against electric shock for direct or indirect contact (DC MAXI JOLLY HC/2 DALI). •Driver for built-in use (DC MAXI JOLLY HC DALI BI). •It can be used for lighting equipment in protection class I. •Active Power Factor Corrector. •Analogical input (NTC) for thermal sensor connection. •Auxiliary output 12 V max. 100 mA. •Current regulation ±5 % including temperature variations. •Input and output terminal blocks on the same side (wire cross-section up to 1,5 – 2,5 mm2 / AWG15 – AWG13). •Clamping screws on primary and secondary circuits for cables with diameter: min. 3 mm – max. 8 mm (DC MAXI JOLLY HC/2 DALI). •Protections: – against overheating and short circuits; – against mains voltage spikes; – against overloads. •Thermal protection = C.5.a. Operation mode: Operation Mode •Light regulation 0/0,5 – 100 % by means of PUSH function, 0/1…10 V interface (I=1 mA) or 100 Kohm potentiometer and DALI. •Features DALI dimming: – memory function for sets or light groups; – recall of stored functions; – compatible with standard DALI interfaces. •Light regulation 0/0,5 – 100 % by means of PUSH function (mains voltage): – a short push to turn on and off; – a longer push to increase or decrease light intensity; – regulation automatically stops at minimum and maximum values; – for another on, regulation or off command, release the push button and give the desired command again. – dimming level memory at mains restore. •Possibility to use PUSH function to 4/5 drivers without sync cable. •Maximum length of the cable, from push button to last driver, must be max. 15 m / 49 ft. In case of applications where the cable is longer than 15 m / 49 ft, keep this separate from the 110 – 240 Volt mains cable. •ATTENTION: only use normally open push buttons with no incorporated warning light. •Specific dimming terminal connection with a 0/1…10 Vdc electronic potentiometer (0/1…10 V local dimming, double insulation required for external connection). •Max. 10 synchronised drivers of which only one can be controlled (1 Master + 9 Slaves). •Synchronization cable is separately supplied.


TCI 55w 1050ma MaxiJolly HC BI Dali Dimmable LED Driver (122417)

Manufacturers Part No (where applicable) : 122417

This TCI product is available for just £5.99
at LampShopOnline Ltd


View Item